Ensure data is for current machine type and control is in correct mode.Įxpecting Upload Request or Command Packet Time Out Re-aim external device and try again.Ĭommunication successful, but the command was not valid for this machine type, or the control could not perform the command in its current mode of operation. Re-insert audit card and wait until machine prompts for card removal.Ĭommunication failure. If error persists, replace control or card reader. Power down, power up and try again.Ĭard reader initialized, communication lost. Control will destroy card.Ĭommunication is valid, but there is no card reader initialization. Replace card readerįaulty firmware in reader. Replace card reader.įaulty firmware in reader.
If error persists, card may be inoperative.įirmware Update Failed, S/W (Software) Intactįirmware load failed.
Download card contents to PC and clear card for re-use. Use a card which does not exceed maximum value.Ĭard memory is full. If error persists, card may be inoperative. Clean chip on card or card reader contacts. Before downloading, ensure data is for current machine type.Ĭommunication failure. Before downloading, ensure data is for current machine type and recheck the programming option's value and try again. Incorrect machine type or the value in at least one of the programming options is invalid or out of range.
Before downloading, ensure data is for current machine type and control is in correct mode. Change sensor.Ĭommunication successful, but the command was not valid for this machine type, or the control could not perform the command in its current mode of operation. Short in temperature sensor circuit wiring. Manually enable IR on control/Re-aim external device and try again. Before downloading, ensure data is for current machine type. Invalid code downloaded from external device to Electronic Control. Re-aim external device and try again.Įxternal device removed before communication complete. Evaluate security procedures.Įxternal device is improperly aimed at infrared communicator (angle or distance). If error persists, tampering may have occurred. Check coin drop area and remove obstructions. Invalid coin pulse or inoperative coin sensor. If door is closed, check for improper wiring or inoperative door switches. The provisions of these Bidder’s Terms shall be binding upon and shall inure to the benefit of the parties hereto, their heirs, successors, and permitted assigns.Service the service door or coin vault switches.ĭoor is not closed during an active cycle. No failure or delay in exercising any right under these Bidder’s Terms shall operate as a waiver of such right, and no single or partial exercise of any such right shall preclude any other or further exercise of such right or any other right. If any provision of these Bidder’s Terms are held invalid or unenforceable in any respect, the parties agree that such term or provision will be deemed to be modified to the extent necessary to permit its enforcement to the maximum extent permitted by applicable law, and the remainder of these Bidder’s Terms and all other provisions hereof will not be affected thereby. No agency, partnership, joint venture, or employment relationship is intended or created by these Bidder’s Terms. The headings in these Bidder’s Terms are for reference only and shall not affect the interpretation of these Bidder’s Terms. You shall not assign any of your rights or delegate any of your duties or obligations under these Bidder’s Terms, whether by operation of law or otherwise, without the prior written consent of Aucto.